Service Center | County Agencies | County Hall
 
space
Building Code Compliance Office
Text Size:
  • Reset
  •   
  • Big
  •   
  • Bigger
  • Home | Product Control | Contractors | Building Officials | Contact Us | miamidade.gov
    space
    space
    Product Control space
  • Approved Product Search
  • Approval Process
  • Certificates of Competency
  • Product Control Forms
  • Notices
  • space
    Contractors space
  • Contractor Inquiry
  • Contractor License Renewal
  • File Contractor Complaints
  • Licensing
  • Examinations
  • Continuing Education
  • C.T. Qualifying Board
  • space
    Building Officials space
  • Building Officials
  • Announcements
  • Notices
  • Continuing Education
  • Alternative Plan Review & Inspection
  • Code Enforcement Personnel
  • The Unsafe Structures Board
  • Board of Rules and Appeals
  • BORA Certification Sub-Committee
  • more >  
    space
    space space
    Print Print Email Email Helpful? Helpful?
    space
    space
    FAQ's Doors

    How many panels for sliding glass doors are required to be tested?

    If you want your approval to read "Approved for 3 panels or less", then test 3 panels and if testing for impact, aim the projectile where specified below.
    Sliding Glass Doors
    If you want your approval to read "Approved for 4 panels or more", then test 4 panels, and if testing for impact, aim the projectile where specified below.
    Sliding Glass Door Panel Testing


    What requirements do roof access doors have at this time?

    No product approvals at this time. Most are steel doors with metal latch.


    When testing doors, how is hardware going to be treated?

    The same principal as anchors will apply. You may qualify up to three different hardware systems for one product's testing. Component approvals are encouraged so that multiple hardware approvals may be received for one product while only testing three.


    Do I have to test all the sizes of doors that I manufacture?

    No. By testing the largest door, you can get approval for all smaller doors of the same type for the same maximum tested pressure.


    If I have a door line that varies only in the size of glazing infill, do I have to test all the different styles?

    No. You may just test the largest door with the largest glazing infill, and get approval for equivalent and smaller doors with proportionally equivalent or smaller glazing infills.


    If I test a double door application, can I get approval for a single door application without testing the single door?

    Yes, provided the double door system consisted of an inactive door leaf.


    Do door applications with side-lites and transoms have to be tested with both in place?

    If that is what you want approval for, yes.


    Where do double swinging glazed doors have to be impacted?
    For double swinging glazed doors the following impact diagram applies.
    Double Swinging Glazed Doors

     


    Is the water test required for entrance doors that have flat sills?

    The water test on this particular product is only required when the roof's overhang is shorter than the height of the wall where the door is located. (If angle theta is greater than 45° then the water test is required on doors with flat sills.) This also applies to residential applications.
     Flat Sill Doors


    space
    space space
    space
    space
    Home  |  Privacy Statement  |  Disclaimer  |  Using Our Site  |  About Us  |  Phone Directory  |  Contact Us
    © 2008 Miami-Dade County. All rights reserved.
    Miami-Dade County Logo